TAILIEUCHUNG - Video Card Installation and System Booting

Upon completion of this lab, the student will have installed the video card. The student will also have connected the mouse, keyboard, and monitor. If everything is installed properly, the student should be able to turn on the computer at the end of this lab. | Lab Video Card Installation and System Booting Estimated time 30 Minutes Objective Upon completion of this lab the student will have installed the video card. The student will also have connected the mouse keyboard and monitor. If everything is installed properly the student should be able to turn on the computer at the end of this lab. Equipment The following equipment is required for this exercise ESD wrist strap Tool kit and screws Video card PS 2 mouse PS 2 Keyboard 15 monitor DOS boot floppy Motherboard manual Scenario A friend cannot wait any longer for the computer to be finished. It is time to put the finishing touches on the machine and start it up. Procedure Before powering up a computer it is extremely important to properly seat all of the expansion cards. If a card is not properly seated when the computer is turned on it will malfunction. Also excessive force when seating an expansion card can damage the motherboard so the job must be done carefully. Step 1 Recall from chapter two that video cards are built for either the PCI slot or the AGP slot. Check the video card that is included in the equipment inventory. In the space below describe the video card. Include how much video RAM is on the card and whether it is a PCI or an AGP card. To install the video card first remove the slot protector from the back of the computer 1 - 4 IT Essentials I - Lab Copyright 2002 Cisco Systems Inc. case. Locate the AGP slot or an available PCI slot. Remove the slot protector by removing the screw that holds it in place. Step 2 Insert the video card into the AGP or PCI slot. If necessary rock it gently until it is seated on the motherboard. After the video card is seated line up the hole in the video card bracket with its corresponding hole in the computer case. Use a case screw to secure the video card to the computer case. Note Never leave a slot open without a card in it. Leaving a slot open will cause poor air circulation in the case and some .

TỪ KHÓA LIÊN QUAN
TAILIEUCHUNG - Chia sẻ tài liệu không giới hạn
Địa chỉ : 444 Hoang Hoa Tham, Hanoi, Viet Nam
Website : tailieuchung.com
Email : tailieuchung20@gmail.com
Tailieuchung.com là thư viện tài liệu trực tuyến, nơi chia sẽ trao đổi hàng triệu tài liệu như luận văn đồ án, sách, giáo trình, đề thi.
Chúng tôi không chịu trách nhiệm liên quan đến các vấn đề bản quyền nội dung tài liệu được thành viên tự nguyện đăng tải lên, nếu phát hiện thấy tài liệu xấu hoặc tài liệu có bản quyền xin hãy email cho chúng tôi.
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.