TAILIEUCHUNG - Model-Based Design for Embedded Systems- P23

Model-Based Design for Embedded Systems- P23:The unparalleled flexibility of computation has been a key driver and feature bonanza in the development of a wide range of products across a broad and diverse spectrum of applications such as in the automotive aerospace, health care, consumer electronics, etc. | 636 Model-Based Design for Embedded Systems Static power mW vs. interconnect length optical link Dynamic power W vs. interconnect length optical link BPT 32 Si - pitch 00 5 10 15 20 b Link length mm FIGURE Power vs. interconnect length for BPT 65 45 and 32 nm technologies a Average static power in mW . b Average dynamic power in W . and to lower detector capacitance which lowers the receiver circuit quiescent current. Dynamic power reductions between Si and S2 of the order of 2-4 are observed. This is attributed mainly to lower transistor capacitances because of lower bias current in the driver due to the reduction in source threshold current and because of lower modulation currents in the driver due to the increase in source efficiency and detector responsivity . Platform for Model-Based Design of Integrated Multi-Technology Systems 637 FIGURE a Total power in mW vs. interconnect length for BPT 65 45 and 32 nm technologies. b Average total power comparison for varying interconnect length and technologies at gm pitch reduction factor. Using static and dynamic power information the total energy can be calculated Figure . The overall power is shown to be reduced between S1 and S2 by factors of between 2 and 4. The greatest reduction is achieved at higher link lengths which is the expected context for the use of such optical links. For 638 Model-Based Design for Embedded Systems S2 power reduction can be considered to be a major argument in favor of optical interconnect. For Si it is clear that the static power comparison is the weak point for optical interconnect because of continuous biasing of the source avoiding turn-on times to achieve the required bit rate and of the receiver circuit the circuit bandwidth is directly related to quiescent bias current . The reduction in source threshold current and in detector capacitance in S2 has a significant impact on both these factors to the extent that the static .

• Quản trị mạng
• Hành trình mạng không dây
• mạng WiFi
• khắc phục sự cố mạng
• chia subnet
• giáo trình mạng máy tính
• Nhiễu kỹ thuật
• kết nối mạng không dây
• mạng không dây
• Các kỹ thuật kết nối mạng không dây
• công nghệ thông tin
• hệ điều hành
• kỹ thuật lập trình
• quản trị mạng
• WiFi
• WiMax
• Lập trình web Internet
• mạng máy tính
• tài liệu mạng máy tính
• chuyên ngành mạng máy tính
• câu hỏi về mạng máy tính
• giáo trình mạng cisco