TAILIEUCHUNG - Hướng dẫn sử dụng Coreldraw x5 - part 79

Tham khảo tài liệu 'hướng dẫn sử dụng coreldraw x5 - part 79', công nghệ thông tin, đồ họa - thiết kế - flash phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 764 CorelDRAW X5 The Official Guide Let s put all this knowledge into practice in the next section. Performing a Trace You re almost set to click OK and have PowerTRACE convert the Silver logo into a set of vector objects. The original logo s text was cast in Motter Fem font if you don t own it this is okay. Install through the Start menu Control Panel Fonts before you begin the tutorial. Candid is not a complete typeface it s missing punctuation marks and numbers and it was created after the Candy font by URW. It s very close in look to Motter Fem and Candy is a great packaging-design font you might seriously consider purchasing for your collection Candid is an author-cobbled knockoff whose purpose is solely to get you through the techniques in the following steps. Reworking a Logo Using Vectors 1. In the PowerTRACE box set the Detail all the way to the right a lower setting would ignore details such as the Catering text because the text is made up of only a few pixels in character width. Set Smoothing at about 25 the logo is already fairly smooth and will not benefit from the averaging PowerTRACE would make in defining paths. 2. Set the Corner Smoothness to the far left on the slider no corner smoothing . You want cusp nodes and sharp corners rendered to keep the checkerboard pieces and serifs on the typefaces sharp. Then check Remove Background check Merge adjacent objects of the same color and then look at the Trace Result Details Curves field just as a matter of practice. 3. Click the Colors tab and then set the Number Of Colors to 30 there really aren t more colors than 30 in the image more colors will create superfluous additional objects. These settings should yield less than 200 separate objects so click OK. 4. Move the objects away from the bitmap original you want to keep the original on the page for reference. Ungroup the group of objects CTRL U and then delete what s left of the word Silver . This will leave a hole in the .

• Đồ họa - Thiết kế - Flash
• Cách sử dụng Corel
• thiết kế trực quan CorelDRAW
• Tạo đối tượng 3D
• công cụ Extrude
• nghệ thuật thiết kế
• phuơng pháp vẽ 3D
• hướng dẫn CrelDraw cơ bản
• Hướng dẫn sử dụng CrelDraw
• công cụ thiết kế đồ họa
• graphics design
• cách dùng Corel DRAW