TAILIEUCHUNG - XBee ZigBee Migration Guide

Document "XBee ZigBee Migration Guide" give you the knowledge: Migration Considerations, Pin Compatibility, Part Number Migration Guide,. Invite you to refer to the lecture content more learning materials and research. | Digi XBee Application Note Migration from XBee XBee-PRO ZB S2 S2B to XBee XBee-PRO ZB S2C This guide will assist you with migrating from the XBee XBee-PRO ZB S2 S2B to the XBee XBee-PRO ZB S2C Through-Hole modules. Even though these XBee modules are similar in function there are some differences that you need to keep in mind. The S2 S2B used the Ember EM250 microprocessor to control the ZigBee Protocol. The XBee XBee-PRO ZB S2C module uses the Ember EM357 this new microprocessor contains much more memory allowing for more flexibility. The footprint of the XBee XBee-PRO ZB S2C Though-Hole is identical to the XBee XBee-PRO ZB S2 S2B and is fully over-the-air OTA compatible. A key change with the XBee XBee-PRO ZB S2C is that six firmware images Coordinator AT Coordinator API Router AT Router API End Device AT and End Device API are combined into a single firmware load. Migration Considerations XBee ZigBee S2 to XBee ZigBee S2C Through-Hole Considerations Considerations XBee ZB S2 XBee-PRO ZB S2B Int l XBee ZB S2C TH Comments Indoor Urban Range up to 133 ft. 40 m Up to 200 ft. 60 m Up to 200 ft. 60 m Improved Outdoor RF line-of-sight Range up to 400 ft. 120 m Up to 5000 ft. 1500 m Up to 4000 ft. 1200 m Improved Transmit Power Output 2mW 3dBm Boost mode 1dBm Normal mode 10 mW 10 dBm 8dBm Boost mode 5dBm Normal mode Channel 26 max power is 3dBm Improved Receiver Sensitivity -96 dBm Boost mode -95 dBm Normal mode -102 dBm -102 dBm Boost mode -100 dBm Normal mode Improved Operating Current Transmit 40mA @ V Boost mode 35mA @ V Normal mode 170 mA @ 45mA 8 dBm Boost mode 33mA 5 dBm Normal mode Slightly higher on boost mode to due to increased output power. Improved on normal mode. Operating Current Receive 40mA @ V Boost mode 38mA @ V Normal mode 45 mA @ 31mA Boost mode 28mA Normal mode Improved SPI Not Supported Not Supported 5 Mbps maximum burst Added SPI interface 1 Number of End Devices 12 12 20 Improved FCC ID OUR-XBEE2 .

• Tiếng Anh thương mại
• XBee ZigBee Migration Guide
• Migration Considerations
• Pin Compatibility
• Part Number Migration Guide
• Migration Guide
• ZigBee Migration Guide