TAILIEUCHUNG - Lead–acid bipolar battery assembled with primary chemically formed positive pasted electrode

Primary chemically formed lead dioxide (PbO2 ) was used as positive electrode in preparation of lead–acid bipolar batteries. Chemical oxidation was carried out by both mixing and dipping methods using an optimized amount of ammonium persulfate as a suitable oxidizing agent. Xray diffraction studies showed that the weight ratio of -PbO2 to -PbO2 is more for mixing method before electrochemical forming. | ELSEVIER Available online at X ScienceDirect Journal of Power Sources 164 2007 896-904 Lead-acid bipolar battery assembled with primary chemically formed positive pasted electrode H. Karamia M. Shamsipurb 1 S. Ghasemia . Mousavia 1 a Department of Chemistry Tarbiat Modares University . Box 14115-175 Tehran Iran b Department of Chemistry Razi University Kermanshah Iran Received 18 February 2006 received in revised form 15 October 2006 accepted 18 November 2006 Available online 20 December 2006 Abstract Primary chemically formed lead dioxide PbO2 was used as positive electrode in preparation of lead-acid bipolar batteries. Chemical oxidation was carried out by both mixing and dipping methods using an optimized amount of ammonium persulfate as a suitable oxidizing agent. X-ray diffraction studies showed that the weight ratio of p-PbO2 to a-PbO2 is more for mixing method before electrochemical forming. The electrochemical impedance spectroscopy EIS was used to investigate charge transfer resistance of the lead dioxide obtained by mixing and dipping methods before and after electrochemical forming. Four types of bipolar lead-acid batteries were produced with 1 lead substrate and conventional electroforming 2 carbon doped polyethylene substrate with conventional electroforming 3 carbon doped polyethylene substrate with chemical forming after curing and drying steps in oxidant bath followed by electrochemical forming and 4 carbon doped polyethylene substrate with primary chemical oxidation in mixing step followed by conventional electroforming. The capacity and cycle-life tests of the prepared bipolar batteries were performed by a home-made battery tester and using the pulsed current method. The prepared batteries showed low weight high capacity high energy density and high power density. The first capacities of bipolar batteries of type 1-4 were found to be 152 150 180 and 198 mAh g-1 respectively. The experimental results showed that the .

TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.