TAILIEUCHUNG - RobotStudio™ 6.03 programming and simulating I/Os

This paper present the content: setting up a simulation from a backup, create system from backup, working with smart components and rapid editor, setup a simulation without action instructions, using the rapid editor to edit the procedures, station logic setup, simulation setup. | Robotstudio Programming and simulating I Os Power and productivity for a better world Ann The information in this manual is subject to change without notice and should not be construed as a commitment by ABB. ABB assumes no responsibility for any errors that may appear in this manual. Except as may be expressly stated anywhere in this manual nothing herein shall be construed as any kind of guarantee or warranty by ABB for losses damages to persons or property fitness for a specific purpose or the like. In no event shall ABB be liable for incidental or consequential damages arising from use of this manual and products described herein. This manual and parts thereof must not be reproduced or copied without ABB s written permission and contents thereof must not be imparted to a third party nor be used for any unauthorized purpose. Contravention will be prosecuted. Additional copies of this manual may be obtained from ABB at its then current charge. Copyright 2016 ABB All right reserved. ABB AB Robotics Products SE-721 68 Vâsterảs Sweden 2016-06-17 ABB Table of Contents 1. Setting up a simulation from a Create System from 2. Working with Smart Components and RAPID Setup a simulation without action Using the RAPID editor to edit the Station Logic Simulation

• Tự động hoá
• Programming and simulating IOs
• Robot studio
• Station logic setup
• Simulation setup
• Rapid editor to edit the procedures