TAILIEUCHUNG - b17 pilot flight instructions

Tham khảo sách 'b17 pilot flight instructions', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | RESTRICTED FOR OFFICIAL USE ONLY AN 01-20EF-1 . NO. 2099C PILOT S FLIGHT OPERATING INSTRUCTIONS FOR ARMY MODELS B-17F and G BRITISH MODEL FORTRESS II This publication shall not be carried in aircraft on combat missions or when there Is a reasonable chance of its falling into the hands of the enemy. AUGUST 1 1943 C2003 Figure 1 - B-17F in Flight 1. AIRPLANE. a. Model B-17F and G bombardment airplanes are four-engine-midwing monoplanes. The approximate over-all dimensions are length 74 feet 9 inches height taxying position 19 feet 1 inch span 103 feet 9 Inches. b. Electrically operated landing gear tail gear wing flaps bomb bay doors and hydraulically operated brakes and cowl flaps are provided. c. The crew includes pilot copilot navigator bombardier upper turret gunner lower turret gunner radio operator side gunner s and tail gunner. The airplane can be entered either through the main entrance door on the right side of the airplane just forward of the horizontal stabilizer or through the front hatch in the bottom of the fuselage below the pilot s compartment. d. Defensive armament of the B-17F consists of three turrets each mounting two .50 calibre machine guns and five single flexibly mounted .50 mounted .50 calibre machine guns. The B-17G has an additional power turret just below the nose of the airplane and controlled from the-bombardier s compartment. e. Provisions are made for loading 2000-pound or smaller bombs on racks within the bomb bay and one bomb up to 4000 pounds may be carried under each wing. f. Automatic flight control equipment is provided. 2. POWER PLANT. a. ENGINES. - The Wright model R-1820-97 engines are air-cooled nine-cylinder radial aircraft engines equipped with integral reduction gears through which the propellers are driven. b. type B-2 General Electric turbosupercharger is provided for each engine to boost manifold pressure for take-off and high-altitude flight. Superchargers are .

• Cơ khí - Chế tạo máy
• Sculptured Surfaces
• Circular Diagrams
• Kinematics of Surface Generation
• Applied Coordinate Systems
• Machine
• (NC) Machine
• Complex Surfaces
• Flank Milling
• Milling of Complex
• Paths Generation
• Behavior
• Tool Paths