TAILIEUCHUNG - Cisco Systems - Router startup and configuration management

Upon completing this lesson, you will be able to: Describe the router boot sequence and explain how to verify that the router booted correctly Identify the internal components of Cisco switches and routers | © 2002, Cisco Systems, Inc. All rights reserved. © 2002, Cisco Systems, Inc. All rights reserved. Router Startup and Configuration Management Purpose: This chapter introduces the Cisco IOS™ CLI on the Catalyst® 1900 switch and router. Timing: This chapter should take about 2 hours to present. Note: The Catalyst 1900 switch only has a subset of the router Cisco IOS commands available. Contents: Introduction to Cisco IOS. Explain to the student what is IOS? Cisco Device startup procedures in general. IOS configuration source. General introduction to the IOS CLI. Cat 1900 switch startup procedures. Intro to Cat 1900 CLI. This part covers the basic configuration on the switch, like setting the IP address and hostname. More details about the various Cat 1900 switch configuration commands are explained in Chapter 6 and 7. Router startup procedures. More details on the router startup process is discussed in chapter 5. Router IOS CLI. Objectives Upon completing this lesson, you will be .

• Quản trị mạng
• Cisco Systems
• Network Devices
• computer
• businesses
• technology operational
• Cisco IOS
• Router startup
• Managing Cisco IOS devices
• Cisco router
• Cấu hình cisco router
• Chức năng cisco router
• Tài liệu IT
• cisco systems – inc
• Tập đoàn hệ thống Cisco
• khách hàng và đối tác
• sản phẩm và dịch vụ
• quy trình đặ hàng
• xử lý đơn hàng
• cisco exam
• cisco CSIDS
• Switching
• management network
• Cisco Switches
• PIX Firewall
• information technology
• international certification
• network cisco
• network Systems
• Cisco TelePresence System
• Linux system
• Starting a switch
• Starting a Router
• Configuring a Router
• network environment
• remove devices
• switch operations
• Redundant topology overview
• tree protocol overview
• Configuring a catalyst switch