TAILIEUCHUNG - Monitoring breathing cracks of a beam like-bridge subjected to moving vehicle using wavelet spectrum

In this paper a wavelet spectrum technique for monitoring the breathing crack phenomenon of a beam-like bridge subjected to moving vehicle is presented. The stiffness of element with a breathing crack is modeled as a time dependent stiffness matrix using the finite element method. | Volume 35 Number 2 2 Vietnam Journal of Mechanics, VAST, Vol. 35, No. 2 (2013), pp. 131 – 145 MONITORING BREATHING CRACKS OF A BEAM-LIKE BRIDGE SUBJECTED TO MOVING VEHICLE USING WAVELET SPECTRUM Nguyen Viet Khoa Institute of Mechanics, Vietnam Academy of Science and Technology 18 Hoang Quoc Viet, Cau Giay, Hanoi E-mail: nvkhoa@ Abstract. In this paper a wavelet spectrum technique for monitoring the breathing crack phenomenon of a beam-like bridge subjected to moving vehicle is presented. The stiffness of element with a breathing crack is modeled as a time dependent stiffness matrix using the finite element method. The stiffness matrix of the structure at each moment depends on the curvature of the structure at the crack position. The breathing crack phenomenon can be detected by analysing the instantaneous frequency (IF) of the system using the wavelet spectrum. When the crack depth is large, the crack area might be determined by the significant peak in the IF. The simulation results show that when the crack “breaths” the amplitude of the vibration obtained from the vehicle is smaller than in the case of an open crack. This is a warning when using the amplitude of the dynamic response to estimate the crack depth when there is a breathing crack in the structure. Therefore, it is important to distinguish the open crack and breathing crack to obtain a more accurate estimation of the crack depth. The results showed that crack with a depth as small as 10% of the beam height can be detected by the method. The proposed method can be applied with a noise level up to 10%. Keywords: Breathing crack, crack detection, damage detection, moving vehicle, moving load, wavelet transform, wavelet-based method, wavelet spectrum. 1. INTRODUCTION The monitoring of cracks in mechanical systems and civil engineering structures has attracted many researchers in the last two decades as reviewed by Salawu [1] and Doebling et al. [2]. There are many nondestructive methods .

• Vật lý
• Vietnam Journal of Mechanics
• Monitoring breathing cracks
• A beam like bridge subjected
• Moving vehicle using wavelet spectrum
• Wavelet based method
• The instantaneous frequency
• Dang Dinh Ang
• Nonlinear analysis and mechanics
• Dynamic problems involving stationary cracks
• The Wiener Hopt technique
• Dual integral equations
• Dual integrals in non linear fracture mechanics
• Non linear fracture mechanics
• Energy release rate
• Discuss the obtained
• The alpha finite element method (αFEM)
• Solid mechanics using triangular and tetrahedral elements
• Suitable computational cost
• NS FEM makes
• The upper bound property
• Non linear constitutive problems in solid mechanics
• Non linear constitutive problems
• Languages Gibian and special operators
• The application FEM
• Betts miller janjic convective parameterization scheme
• H14 31 model to forecast heavy rainfall in Vietnam
• Betts Miller Janjic
• Three rain seasons
• Manufacturing dry mixed cement mortar
• High compressive strength
• High flexural strength
• Low shrinkage and high watertightness for restoration
• Damaged hydraulic structures in Vietnam
• Standard gradient models and crack simulation
• Standard gradient models
• The propagation of cracks
• Damage mechanics and crack simulation
• The interaction between two parametric excitations
• The second and third degrees
• The asymptotic method of nonlinear mechanics
• Dynamic system governed
• Comparison of two hydrological model simulations
• Nam and Xinanjiang for Nong Son catchment
• The Central Vietnam
• The runoff components
• 3 D numerical simulation
• The tidal circulation
• The gulf of Tonkin
• The kinetic energy distribution
• Duality in the analysis of responses to nonlinear systems
• The analysis of responses
• The original nonlinear systems
• The study of nonlinear mechanics
• Aerodynamics of a wing in surface effect ship
• Theory and experiment
• Wing in surface effect ship
• The aerodynamic characteristics
• The Institute of Mechanics
• The error estimate
• The convergence rate for h
• p refinement
• The finite element analysis
• Three dimensional elastostatic mechanics problems
• Some initial experimental results
• Free water layer formation in horizontal pipes
• Water layer formation
• Hanoi Institute of Mechanics
• Bending vibration of beam elements under moving loads
• Considering vehicle braking forces
• Fluctuations of structures
• Beam elements according
• Continuous element for vibration analysis
• Thick shells of revolution
• Continous Element Method
• Finite element solutions
• Natural frequencies and harmonic responses
• Cast3m implementation of the extended finite element method
• The extended finite element method for cohesive crack
• Quasi brittle materia
• The proposed implementation
• The displacement discontinuities
• Buckling analysis of simply supported composite laminates subjected
• In plane compression load
• A novel mesh ffree method
• Alternative numerical technique
• Mesh free method
• A three story building
• Hedge algebras based fuzzy controller
• The structural system
• The El Centro earthquake
• Three story building against earthquake
• Laminar separation phenomenon combining with numerical calculations
• The turbulent separation
• The laminar separation
• Experimental study on mechanical properties
• Three phase polymer composite reinforced
• Glass fibers and titanium oxide particles
• Polymer composite reinforced
• Three phase composite
• Dynamic characteristics of elastically supported beam subjected
• A compressive axial force and a moving load
• The implicit Newmark method
• The Galerkin finite element method
• The axial force
• Eccentrically stiffened functionally graded plates and shallow shells
• Von Karman Donnell sense
• The formulation of governing equations
• The classical shell theory
• Mathematical modelling and control of the evolution
• Dynamic systems interacting with medium
• Mathematical modeling evolutional systems interacting
• Two conjugate mechanical subsystems
• Evaluating structural safety based on fuzzy set theory
• Evaluating structural safety
• The fuzzy reliability
• Simple beam structure