TAILIEUCHUNG - Hướng dẫn sử dụng Coreldraw x5 - part 20

Tham khảo tài liệu 'hướng dẫn sử dụng coreldraw x5 - part 20', công nghệ thông tin, đồ họa - thiết kế - flash phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 174 CorelDRAW X5 The Official Guide The upper limit for nudge distance is 600 inches which is fair enough because for example nudging a shape 600 inches to move it is more easily accomplished by simply entering the intended position in the property bar s X and Y fields then you press ENTER to apply the move . NOTE Nudge distance can be set on-the-fly within the workspace and Super and Micro Nudge scale apply to the new nudge distance. With nothing selected set a new value in the Nudge Distance box. There s an easy way to remember some modifier keys. In many applications CTRL means constrain to limit while SHIFT often means to add to or to extend. So super-nudging can be thought of as an extension to normal nudge distances you hold SHIFT while pressing arrow keys and micro-nudging is a constrained version of normal nudging you hold CTRL . Specifying Units Origin and Tick Divisions for Your Rulers In the fields below Nudge options you ll find all the controls for what appears and where on the rulers displayed on your drawing page. Here s how each option controls ruler appearance Units Units are measurement values. Choose a Horizontal unit measure to specify unit measures for all drawing units in your document. To specify different units of measure for vertical ruler and drawing units click to deselect the Same Units For Horizontal And Vertical Rulers option shown in Figure 7-4. Origin Although you can manually set the origin as described in the previous section you can also perform precise origin definition using this field. The origin point can be set anywhere from -50 to 50 yards in precise increments as small as inch. Tick Divisions Tick divisions are the evenly spaced numeric labels seen bracketing the smaller increments displayed by your ruler for example if you are using inches as the unit the tick divisions are 1 2 3 and so on. Tick divisions are automatically set according to the unit of measure selected. For example standard measure displays a default

• Đồ họa - Thiết kế - Flash
• Cách sử dụng Corel
• thiết kế trực quan CorelDRAW
• Tạo đối tượng 3D
• công cụ Extrude
• nghệ thuật thiết kế
• phuơng pháp vẽ 3D
• hướng dẫn CrelDraw cơ bản
• Hướng dẫn sử dụng CrelDraw
• công cụ thiết kế đồ họa
• graphics design
• cách dùng Corel DRAW