Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ
Tải xuống
Tham khảo đề thi - kiểm tra 'câu hỏi trắc nghiệm ccna 2 - chương 7', công nghệ thông tin, chứng chỉ quốc tế phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 1 What field was added to the RIP message header by RFC 1723 to add support for VLSM and CIDR subnet mask destination port number address family identifier source and destination IP addresses 2 s 0 0 0 so o o SO. O I __ so o o JAX ORL R Refer to the exhibit. All routers are running RIP version 2. JAX is configured to just advertise the 10.0.0.0 2 172.16.0.0 16 10.0.0.0 24 LOOPO O 192.168.2.1 24 ORL config ip route 192.168.0.0 255.255.0.0 s 0 0.0 ORL configi router rip ORL config-router version 2 ORL config-router network 10.0.0.0 ORL config-router network 172.16.0.0 ORL conf ig-router redistrtoute static 192.168.1.1 24 FA0 0 _ network. CHI is configured to advertise the 172.16.0.0 16 network. A network administrator enters the commands shown in the exhibit. What changes will occur in this network The JAX router will ignore updates for the 172.16.0.0 16 network due to split horizon issues. The CHI router will install a route to the 192.168.0.0 16 network in its routing table. The routing table for CHI will have the 192.168.0.0 16 route but it will have an S next to the route. The ORL router will apply a 255.255.0.0 subnet mask to all networks in the routing updates it forwards. 3 192.168.1.16 28 10.0.8.0 8 JAX debug ip rip RIP protocol debugging is on RIP sending v1 update to 255.255.255.255 via FastEthernetO O 192.168.1.17 RIP build update entries network 10.0.0.0 metric 3 network 172.16.0.0 metric 2 RIP received v1 update from 192.168.1.6 on SerialO O O 10.0.0.0 in 2 hops 172.16.0.0 in 1 hops efer to the exhibit. The exhibited network contains a mixture of Cisco and non-Cisco routers. The commani debug ip rip was entered on the JAX router. All routers are running the same version of RIP. Router CHI an Router ORL are not able to reach the 192.168.1.16 28 network. What is a possible solution to this problem Enable split horizon in the network. Configure RIPv2 on routers. Add network 192.168.1.0 to the RIP configuration on the JAX router. Configure JAX Fa0 0
