Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ
Tải xuống
Tham khảo tài liệu 'volume 1 mechanical science handbooks doe-hdbk part 4', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | DIESEL ENGINES DOE-HDBK-1018 1-93 Diesel Engine Fundamentals These rings function as the seal between the piston and the cylinder wall and also act to reduce friction by minimizing the contact area between the piston and the cylinder wall. The rings are usually made of cast iron and coated with chrome or molybdenum. Most diesel engine pistons have several rings usually 2 to 5 with each ring performing a distinct function. The top ring s acts primarily as the pressure seal. The intermediate ring s acts as a wiper ring to remove and control the amount of oil film on the cylinder walls. The bottom ring s is an oiler ring and ensures that a supply of lubricating oil is evenly deposited on the cylinder walls. Connecting Rod The connecting rod connects the piston to the crankshaft. See Figure 2 and Figure 3 for the location of the connecting rods in an engine. The rods are made from drop-forged heat-treated steel to provide the required strength. Each end of the rod is bored with the smaller top bore connecting to the piston pin wrist pin in the piston as shown in Figure 6. The large bore end of the rod is split in half and bolted to allow the rod to be attached to the crankshaft. Some diesel engine connecting rods are drilled down the center to allow oil to travel up from the crankshaft and into the piston pin and piston for lubrication. A variation found in V-type engines that affects the connecting rods is to position the cylinders in the left and right banks directly opposite each other instead of staggered most common configuration . This arrangement requires that the connecting rods of two opposing cylinders share the same main journal bearing on the crankshaft. To allow this configuration one of the connecting rods must be split or forked around the other. Crankshaft The crankshaft transforms the linear motion of the pistons into a rotational motion that is transmited to the load. Crankshafts are made of forged steel. The forged crankshaft is machined to produce .
