Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ
Tải xuống
Tham khảo tài liệu 'migrating from rip to eigrp', công nghệ thông tin, quản trị mạng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 3.6.1 Migrating from RIP to EIGRP Host B 192.168.3.2 24 Fa0 0 192.168.3.1 24 S0 0 192.168.1.1 24 Vista S0 0 192.168.1.2 24 Fa0 0 10.0.0.1 8 S0 1 192.168.2.1 24 S0 0 192.168.2.2 24 SanJosel SanJose2 Fa0 0 10.0.0.2 8 Host A 10.0.0.11 8 Objective In this lab you configure RIPv2 and then EIGRP so that you can compare their metric calculations. Scenario International Travel Agency ITA currently uses RIPv2 as its interior gateway protocol. You have been asked to migrate its network to EIGRP. Step 1 Build and configure the network according to the diagram. Note Host A and Host B are not required to complete this lab but they might be used in testing or as Telnet clients. If used Host A s gateway may be either SanJosel router or the SanJose2 router. On all three routers configure RIPv2 and enable updates on all active interfaces with the network command. Here are some sample commands for SanJosel SanJose1 config router rip SanJose1 config-router version 2 SanJose1 config-router network 192.168.1.0 SanJose1 config-router network 10.0.0.0 Use ping and show ip route to verify full connectivity within the network. 1 - 3 Semester 5 Advanced Routing v2.0 - Lab 3.6.1 Copyright 2001 Cisco Systems Inc. Step 2 As you migrate to EIGRP you decide to leave RIP running on all the routers to avoid a loss of connectivity. On SanJosel and SanJose2 configure EIGRP for Autonomous System 24 as shown below. Do not configure Vista for EIGRP yet. SanJose1 config router eigrp 24 SanJose1 config-router network 192.168.1.0 SanJose1 config-router network 10.0.0.0 and SanJose2 config router eigrp 24 SanJose2 config-router network 192.168.2.0 SanJose2 config-router network 10.0.0.0 Step 3 From Vista s console issue the show ip route command. Because you have not yet configured EIGRP on this router you should have a route to the 10.0.0.0 8 network via RIP. 1. What is the administrative distance of this route 2. What is the metric of this route Enable debug so that changes to the routing table will be .
