Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ
Tải xuống
• Network errors are in the form of corrupted data or lost data. • Network errors occur naturally on all networks due to electrical noise and distortion and must be detected and corrected by either hardware or software. • Bit Error Rates (BERs) are calculated as the number of bits in error divided by the number of bits transmitted. A BER of 1 in 100,000 might be shown as 1:105 or simply as a BER of 10-5 . • Errors often occur in bursts where many bits in a sequence will be in. | CSN200 Introduction to Telecommunications, Fall 1999 Lecture-09 Error Sources, Detection and Correction Error Sources, Detection and Correction The Data Link Layer [Ref: Chap-5 Fitzgerald & Dennis, Chap-5 p.142 Stallings] Error Control In Networks: • Network errors are in the form of corrupted data or lost data. • Network errors occur naturally on all networks due to electrical noise and distortion and must be detected and corrected by either hardware or software. • Bit Error Rates (BERs) are calculated as the number of bits in error divided by the number of bits transmitted. A BER of 1 in 100,000 might be shown as 1:105 or simply as a BER of 10-5. • Errors often occur in bursts where many bits in a sequence will be in error. What are Network Errors and What Causes Errors? Noise is any form of undesirable electrical signals introduced by equipment or natural disturbances (lightening). Noise has the effect of causing bits to change state, extra bits or missing bits resulting in errors in a message. Forms of Line Noise and Distortion: • White Noise Caused by the thermal agitation of electrons in all matter. Always present (like the background hiss on radios) but not usually a problem unless the signal itself is very weak. • Impulse Noise Noise spikes (large voltage fluctuations on the line) are a primary source of errors. Caused by telephone system equipment, lightening, fluorescent lights, poor electrical connections, etc. A 1/100 second voltage spike would damage at least 144 bits if transmission was at 14,400 bps. • Cross-talk Signals picked up on one circuit from adjacent circuits. (We often hear this in voice telephone calls when we hear a faint conversation going on in the background.) lecture 09.doc Page 1 (6) CSN200 Introduction to Telecommunications, Fall 1999 Lecture-09 Error Sources, Detection and Correction • Intermodulation Noise A special type of crosstalk. The signals from two circuits combine to form a new signal that falls into a frequency band .