Đang chuẩn bị liên kết để tải về tài liệu:
RAPID PROTOTYPING TECHNOLOGY – PRINCIPLES AND FUNCTIONAL REQUIREMENTS

Under the umbrella of Rapid-X (Udroiu & Ivan, 2008) there are some specific terms such as: Rapid Product Development (RPD), Rapid Technology, Rapid Nanotechnology, Rapid Prototyping (RP), Rapid Tooling (RT) and Rapid Manufacturing (RM). Additive manufacturing (AM) is an important component of the rapid product development process. Additive manufacturing technologies (AMT) represents a group of technologies used for building physical models, prototypes, tooling components and finished parts, all from three dimensional (3D) computer aided design (CAD) data or data from 3D scanning system | RAPID PROTOTYPING TECHNOLOGY - PRINCIPLES AND FUNCTIONAL REQUIREMENTS Edited by Muhammad Enamul Hoque INTECHWEB.ORG Rapid Prototyping Technology - Principles and Functional Requirements Edited by Muhammad Enamul Hoque Published by InTech Janeza Trdine 9 51000 Rijeka Croatia Copyright 2011 InTech All chapters are Open Access articles distributed under the Creative Commons Non Commercial Share Alike Attribution 3.0 license which permits to copy distribute transmit and adapt the work in any medium so long as the original work is properly cited. After this work has been published by InTech authors have the right to republish it in whole or part in any publication of which they are the author and to make other personal use of the work. Any republication referencing or personal use of the work must explicitly identify the original source. Statements and opinions expressed in the chapters are these of the individual contributors and not necessarily those of the editors or publisher. No responsibility is accepted for the accuracy of information contained in the published articles. The publisher assumes no responsibility for any damage or injury to persons or property arising out of the use of any materials instructions methods or ideas contained in the book. Publishing Process Manager Mirna Cvijic Technical Editor Teodora Smiljanic Cover Designer Jan Hyrat Image Copyright Adisa 2011. Used under license from Shutterstock.com First published September 2011 Printed in Croatia A free online edition of this book is available at www.intechopen.com Additional hard copies can be obtained from orders@intechweb.org Rapid Prototyping Technology - Principles and Functional Requirements Edited by Muhammad Enamul Hoque p. cm. ISBN 978-953-307-970-7 ikrrr iJ OPEN ACCESS INI Cvn PUBLISHER INTECH open free online editions of InTech Books and Journals can be found at .