Đang chuẩn bị liên kết để tải về tài liệu:
Lab 6.2.7b Managing Switch Startup Configuration Files

Tham khảo tài liệu 'lab 6.2.7b managing switch startup configuration files', công nghệ thông tin, quản trị mạng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Cisco Systems I Lab 6.2.7b Managing Switch Startup Configuration Files fl. FAO 1 Switch Designation Switch Name Enable Secret Password Enable VTY and Console Passwords VLAN 1 IP Address Default Gateway IP Address Subnet Mask Switch 1 AL Switch ciass cisco 192.168.1.2 192.168.1.1 255.255.255.0 Straight-through cable Serial cable -Z _ Console Rollover . Crossover cable _ . Objective Create and verify a basic switch configuration. Backup the switch startup configuration file to a TFTP server and then restore it. Background Preparation Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Start a HyperTerminal session. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. Step 1 Configure the switch Configure the hostname access and command mode passwords as well as the management LAN settings. These values are shown in the chart. If problems occur while performing this configuration refer to the Basic Switch Configuration lab. 1 - 5 CCNA 3 Switching Basics and Intermediate Routing v 3.0 - Lab 6.2.7b Copyright 2003 Cisco Systems Inc. Step 2 Configure the host attached to the switch Configure the host to use the same subnet for the address mask and default gateway as on the switch. This host will act as the TFTP server in this lab. Be sure to take note of the IP address assigned. Step 3 Verify connectivity a. To verify that the host and switch are correctly configured ping the switch IP address from the host. b. Was the ping successful c. If the answer is no troubleshoot the host and switch configurations. Step 4 Starting and configuring the Cisco TFTP server a. The TFTP .