TAILIEUCHUNG - Design of plant, equipment and workplaces

For all buildings combined, the average plug-load equipment density in units per 1000 gross ft 2 , was about 9 for office equipment and 14 for miscellaneous equipment, for a sum of about 23 units per 1000 gross ft 2 . Educational buildings, where large floor areas are devoted to classrooms, had the lowest density of both office and miscellaneous equipment. However, two-thirds of computers and monitors found in educational buildings (and thus most of the energy savings potential) were concentrated in computer-based classrooms. Among offices only (for which we were able to estimate number of employees, or occupants), the average equipment density, . | L134 Design of plant equipment and workplaces Dangerous Substances and Explosive Atmospheres Regulations 2002 APPROVED CODE OF PRACTICE AND GUIDANCE IE HSE L134 Design of plant equipment and workplaces Dangerous Substances and Explosive Atmospheres Regulations 2002 APPROVED CODE OF PRACTICE AND GUIDANCE HSEBOOKS Crown copyright 2003 First published 2003 ISBN 0 7176 2199 5 All rights reserved. No part of this publication may be reproduced stored in a retrieval system or transmitted in any form or by any means electronic mechanical photocopying recording or otherwise without the prior written permission of the copyright owner. Applications for reproduction should be made in writing to Licensing Division Her Majesty s Stationery Office St Clements House 2-16 Colegate Norwich NR3 1BQ or by e-mail to hmsolicensing@ This Code has been approved by the Health and Safety Commission with the consent of the Secretary of State. It gives practical advice on how to comply with the law. If you follow the advice you will be doing enough to comply with the law in respect of those specific matters on which the Code gives advice. You may use alternative methods to those set out in the Code in order to comply with the law. However the Code has special legal status. If you are prosecuted for breach of health and safety law and it is proved that you did not follow the relevant provisions of the Code you will need to show that you have complied with the law in some other way or a court will find you at fault. The Regulations and Approved Code of Practice ACOP are accompanied by guidance which does not form part of the ACOP. Following the guidance is not compulsory and you are free to take other action. But if you do follow the guidance you will normally be doing enough to comply with the law. Health and safety inspectors seek to secure compliance with the law and may refer to this guidance as illustrating good practice. .

TỪ KHÓA LIÊN QUAN
TAILIEUCHUNG - Chia sẻ tài liệu không giới hạn
Địa chỉ : 444 Hoang Hoa Tham, Hanoi, Viet Nam
Website : tailieuchung.com
Email : tailieuchung20@gmail.com
Tailieuchung.com là thư viện tài liệu trực tuyến, nơi chia sẽ trao đổi hàng triệu tài liệu như luận văn đồ án, sách, giáo trình, đề thi.
Chúng tôi không chịu trách nhiệm liên quan đến các vấn đề bản quyền nội dung tài liệu được thành viên tự nguyện đăng tải lên, nếu phát hiện thấy tài liệu xấu hoặc tài liệu có bản quyền xin hãy email cho chúng tôi.
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.