TAILIEUCHUNG - AIR POLLUTION CONTROL TECHNOLOGY HANDBOOK - CHAPTER 14

Sự ngưng tụ hơi nước từ một dòng không khí có thể xảy ra như là một bộ phim của vật liệu đặc trên tường của ống ngưng tụ hoặc là một loạt các giọt hình thành tại các điểm khác nhau trên bề mặt. Phim loại ngưng tụ là cơ chế thường gặp trong bình ngưng. Bộ phim thống nhất áo khoác bề mặt, và độ dày của bộ phim tăng lên với mức độ của bề mặt. Trong dropwise ngưng tụ, bề mặt không phải là thống nhất được bảo hiểm. Những giọt cá nhân hình thành và. | 14 Control of VOC and HAP by Condensation INTRODUCTION Condensation of a vapor from an air stream can take place as a film of the condensed material on the wall of the condenser tube or as a series of drops that form at various points on the surface. Film-type condensation is the more common mechanism encountered in a condenser. The film uniformly coats the surface and the thickness of the film increases with the extent of the surface. In dropwise condensation the surface is not uniformly covered. The individual drops form and grow on the surface and tend to coalesce with neighboring drops. Adhesion of the drops is then overcome by gravitational forces and the coalesced drops run off the surface. Impurities in the vapor stream promote dropwise condensation which results in higher heat transfer coefficients. Unfortunately there is not much information available on dropwise condensation. Therefore design methods are limited to the film-type case. Condensers are best applied for removal of VOC and HAP from emission streams when the concentration is greater than 5000 ppmv. Removal efficiencies range from 50 to 90 . The upper end of efficiencies are practically achievable for concentrations in the range of 10 000 ppmv or greater. With high concentrations of pollutant condensers are frequently employed as preliminary air-pollution-control devices prior to other devices such as incinerators absorbers or adsorbers. Flows up to 2000 scfm can be handled in condensers. In condensation one or more volatile components of a vapor mixture are separated from the remaining vapors through saturation followed by a phase change. The phase change from gas to liquid can be achieved by increasing the system pressure at a given temperature or by lowering the temperature at a constant pressure. The lower the normal boiling point the more volatile the compound the more difficult to condense and the lower the temperature required for condensation. Refrigeration must often be employed to

TỪ KHÓA LIÊN QUAN
TAILIEUCHUNG - Chia sẻ tài liệu không giới hạn
Địa chỉ : 444 Hoang Hoa Tham, Hanoi, Viet Nam
Website : tailieuchung.com
Email : tailieuchung20@gmail.com
Tailieuchung.com là thư viện tài liệu trực tuyến, nơi chia sẽ trao đổi hàng triệu tài liệu như luận văn đồ án, sách, giáo trình, đề thi.
Chúng tôi không chịu trách nhiệm liên quan đến các vấn đề bản quyền nội dung tài liệu được thành viên tự nguyện đăng tải lên, nếu phát hiện thấy tài liệu xấu hoặc tài liệu có bản quyền xin hãy email cho chúng tôi.
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.