TAILIEUCHUNG - PSIM User Manual phần 8

biến tăng điện áp điều khiển điện áp nguồn (VVCVSV) - Variable-tăng điện áp kiểm soát nguồn hiện tại (IVCCSV) Đối với điện áp kiểm soát hiện tại / hiện tại nguồn (VCCVS / ICCCS), hiện nay kiểm soát phải đến từ một chi nhánh RLC. Ngoài ra, một nguồn dòng điều khiển, điện áp kiểm soát / hiện tại không thể là một nguồn độc lập. | Sources Voltage Current-Controlled Sources Four types of controlled sources are available - Voltage controlled voltage source VVCVS - Current controlled voltage source VCCVS VCCVS_1 - Voltage controlled current source IVCCS - Current controlled current source ICCCS ICCCS_1 - Variable-gain voltage controlled voltage source VVCVSV - Variable-gain voltage controlled current source IVCCSV For current controlled voltage current source VCCVS ICCCS the controlling current must come from a RLC branch. Also for a controlled current source the controlling volt-age current can not be an independent source. Note that voltage current-controlled sources can be used in the power circuit only. Images VVCVS VCCVS VCCVS_1 IVCCS ICCCS ICCCS_1 VVCVSV IVCCSV Attribute Parameters Description Gain Gain of the source For voltage-controlled sources VVCVS IVCCS the controlling voltage is from the positive node to the negative node - . For current-controlled sources VCCVS ICCCS the control nodes are connected across a RLC branch and the direction of the controlling current is indicated by the arrow. For current-controlled sources VCCVS_1 ICCCS_1 the controlling current flows into one control node and out of the other. A 10-uOhm resistor is used to sense the controlling current. For variable-gain controlled voltage current sources Input 1 is on the side with the multiplication sign and Input 2 is on the side with the letter k For the controlled voltage current sources the output is equal to the gain multiplied by the controlling voltage or current respectively. For the variable-gain controlled voltage cur-rent sources however the output is equal to the following vo k vin 1 vin1 PSIM User Manual 4-9 Chapter 4 Other Components io k vin2 vin1 The difference between the variable-gain controlled sources and the nonlinear sources VNONM INONM described in the following section is that for VNONM INONM values of both vin1 and vin2 at the current time step are used to calculate the output and .

TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.