TAILIEUCHUNG - Báo cáo lâm nghiệp: "Discrimination of coated carbide tools wear by the features extracted from parallel force and noise level"

Tuyển tập các báo cáo nghiên cứu về sinh học được đăng trên tạp chí lâm nghiệp đề tài: Discrimination of coated carbide tools wear by the features extracted from parallel force and noise level. | 731 Ann. For. Sci. 61 2004 731-736 INRA EDP Sciences 2004 DOI forest 2004070 Note Discrimination of coated carbide tools wear by the features extracted from parallel force and noise level Wayan DARMAWANa b Chiaki TANAKAc a Faculty of Forestry Bogor Agricultural University Kampus IPB Darmaga Bogor 16680 Indonesia b Current address Dept. Teknologi Hasil Hutan Fakultas Kehutanan Kampus IPB Darmaga Bogor 16680 Indonesia c Faculty of Science and Engineering Shimane University Nishikawatsu-cho 1060 Matsue Shimane 690-8504 Japan Received 27 February 2003 accepted 2 July 2004 Abstract - Coated carbide tools were tested for turning of wood-chip cement board. Coating materials which were synthesized on the P30 carbide substrate are titanium carbonitride titanium nitride chromium nitride and titanium nitride aluminum nitride. Cutting tests were performed at cutting speeds of 30 40 50 and 60 m s depth of cut of 1 mm and feed of mm rev. Wear parallel force and noise level were measured at every specified cutting length. The purpose was to discriminate various stages of wear of the coated carbide tools by the features extracted from parallel force and noise level. The results of the study show that both the parallel force and noise level generated by the tools tested were observed to increase linearly with increasing the tools wear and would be good parameters for monitoring the tool wear. The parallel force and the noise level of the cutting tools also increased with increasing the cutting speeds for every specified cutting length. The parallel force became more sensitive than the noise level for monitoring the tool wear when the cutting speed was increased. coated carbide tool parallel force noise level wood-chip cement board cutting speed Résumé - Estimation de l usure d outils carbures revêtus à partir de paramètres extraits de l analyse du bruit et des efforts de coupe. Des outils carbure ont été testés dans un essai de tournage de panneaux bois ciment. Le .

TÀI LIỆU LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.