TAILIEUCHUNG - A Practical Guide to Particle Counting for Drinking Water Treatment - Chapter 7

Bộ cảm biến Xây dựng hạt A. FLOW CELL Các tế bào dòng chảy là một phần nền tảng của bộ cảm biến truy cập hạt. Nó thường được làm bằng nhôm hoặc thép không gỉ hoặc thậm chí nhựa. Thép không gỉ là tốn kém hơn chủ yếu bởi vì nó là khó khăn hơn nhiều so với nhôm và do đó khó khăn hơn cho máy tính. Nhôm phải được tráng hoặc anodized đặc biệt để ngăn ngừa rỗ khi tiếp xúc với nước. Mẫu chảy qua một kênh hình thành bởi các tế bào dòng chảy và khe. | CHAPTER 7 Particle Sensor Construction A. FLOW CELL The flow cell is a foundation piece of the particle counter sensor. It is generally made out of aluminum or stainless steel or even plastic. Stainless steel is more expensive primarily because it is much harder than aluminum and thus more difficult to machine. Aluminum must be coated or specially anodized to prevent pitting when exposed to water. The sample flows up through a channel formed by the flow cell windows and the slit through the flow cell. The sample tube fittings are mounted into the flow cell on both ends of the slit. In most cases the laser optics assembly and the detector circuit are bolted to either side of the flow cell. See Figure . The flow cell must be rigid enough to hold all these pieces together without allowing any alteration in alignment which would result in the particle counter sensor losing calibration. The cell windows must fit tightly and be sealed to prevent sample leakage. The materials of construction are not important as long as the functional integrity is maintained. The ability to withstand repeated cleanings and clog removal is a necessity. B. CELL WINDOWS The cell windows employed are usually round disks of synthetic sapphire with flat polished surfaces. These windows are seated on either side of flow cell slit and sealed with O-rings to create the flow cell path. Quartz can be used for this type of window as well or can be drilled and polished to produce a single four-sided piece that contains the flow cell path as well. The laser light beam is sent through the center of the window through the flow cell path and then out the other side where it strikes the detector. 81 2001 by CRC Press LLC 82 A PRACTICAL GUIDE TO PARTICLE COUNTING Laser Diode Holder Pin Photodiode animation a Sensor Cover Power Regulator Flow Ce Channel nn Signal Amplification Board Flow Cell Housing Op Spacer Adjust Focus Optics Sapphire Windows 780 nm Laser Diode Figure Particle sensor. .

TÀI LIỆU LIÊN QUAN
TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.