TAILIEUCHUNG - Simple Computer Tune-up: Speed Up Your PC- P39

Simple Computer Tune-up: Speed Up Your PC- P39: As more and more software becomes available and computers increase in complexity, problems with performance are cer- tain to arise. If your PC is misbehaving, don’t let it ruin your book explains how to make the best out of your PC by using PC Pitstop Optimize, which cures many PC “sicknesses” with- out the need for upgrading or replacing your existing PC. | 172 Part III Bonus Material 4. Remove the computer s cover. For more information refer to the section Open Your Computer s Case in Chapter 12. 5. On the rear of the new CD or DVD drive is a tiny plastic jumper that must be placed onto the small metal pins in a specific way to allow the drive to work side by side with the hard drives or other CD DVD drives in your system. On the top or rear of most CD or DVD drives is a diagram or picture that shows where to place the jumper to make the drive a slave. Although many CD or DVD drives are already configured to be slaves yours may not be. In that case follow the diagram or picture to make your new drive a slave. 6. Connect a data cable to the new CD or DVD drive. To do so find the ribbon cable connected to your hard drive and then use the gray connector in the middle of it to connect to your CD or DVD drive. 7. Connect a power cable to the new CD or DVD drive. Usually all computers have extra power cables tucked away inside their cases. 8. If you want to hear audio from any CDs or DVDs played on your new drive you may need to connect an audio cable between the drive and the CD-audio input slot on your sound card or motherboard. For more details refer to the owner s manual or documents that came with your computer. 9. Find an empty mounting bay inside the computer s case and then slide the new CD or DVD drive into the bay and secure it usually by screwing the drive to the case . 10. If any wires or cables inside the computer were accidentally disconnected while installing the CD or DVD drive reconnect them. 11. Close the case and then return the base unit to your desk. 12. Reconnect the wires and cables into the back of the base unit and then plug the computer into an electrical outlet and turn it on. 13. Windows should automatically detect the new CD or DVD drive and enable you to use it right away. Replace Your Floppy Drive Most people no longer use old-fashioned floppy disks which is why many new computers don t .

• Phần cứng
• sửa chữa máy tính
• sổ tay phần cứng
• MainBoard
• thiết bị máy tính
• thiết bị mạng
• lắp ráp máy tính
• Phần cứng máy tính
• lỗi máy tính
• hệ thống mạch máy tính
• điện máy tính
• Tài liệu máy tính