TAILIEUCHUNG - Antennas with Non-Foster Matching Networks phần 5

Tham khảo tài liệu 'antennas with non-foster matching networks phần 5', kỹ thuật - công nghệ, kĩ thuật viễn thông phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 38 ANTENNAS WITH NON-FOSTER MATCHING NETWORKS a b FIGURE 42 Simulated a return loss and b stability of the all-pass test circuit for the THS3202 FNR An all-pass implementation simulation in Agilent ADS with R3 50Q is depicted in Fig. 44 where the FNR is placed inside a two-port data item box. To minimize noise and maximize gain R1 and R2 are chosen to be as small as possible 200 Q and 400 Q respectively without affecting the performance of the FNR. The two 25 Q resistors on each side of the FNR complete the all-pass test circuit. The simulation results of Fig. 45 show that the -20 dB return loss bandwidth is only about 30 MHz but the network is close to being unconditionally stable over almost the entire frequency range. We found that the input reactance Xin is negative and so might be compensated over a limited frequency range using a series inductor. By trial and ANTENNAS WITH NON-FOSTER MATCHING NETWORKS 39 FIGURE 43 Schematic captured from Agilent ADS of the THS3202 FNR circuit formed by two back-to-back GNRs S-PARAMETERS S_Param SP 1 Start 10 MHz Stop 300 MHz Step 1000 kHz MuPrime MuPrime MuPrime 1 MuPrime 1 mu_prime S Floating_NIC_Back_to_Back_port X1 -AAA - R R9 R 25 Ohm R R10 R 25 Ohm Term Term1 Num 1 Z 50 Ohm Term Term2 Num 2 Z 50 Ohm FIGURE 44 Schematic captured from Agilent ADS of the THS3202 FNR of Fig. 42 installed in the all-pass evaluation circuit 40 ANTENNAS WITH NON-FOSTER MATCHING NETWORKS freq MHz b FIGURE 45 Simulated a return loss and b stability of the all-pass test circuit for the THS3202 FNR formed by two back-to-back GNRs error we found that placing an inductance of 45 nH in series with the FNR maximized the return loss bandwidth and stability of the all-pass test circuit as shown in Fig. 46. The simulated -15 dB return loss bandwidth is expanded to greater than 250 MHz. Unfortunately the circuit is not unconditionally stable for frequencies less than 125 MHz but may be relatively easy to stabilize since ự is so close to unity. Another way

TAILIEUCHUNG - Chia sẻ tài liệu không giới hạn
Địa chỉ : 444 Hoang Hoa Tham, Hanoi, Viet Nam
Website : tailieuchung.com
Email : tailieuchung20@gmail.com
Tailieuchung.com là thư viện tài liệu trực tuyến, nơi chia sẽ trao đổi hàng triệu tài liệu như luận văn đồ án, sách, giáo trình, đề thi.
Chúng tôi không chịu trách nhiệm liên quan đến các vấn đề bản quyền nội dung tài liệu được thành viên tự nguyện đăng tải lên, nếu phát hiện thấy tài liệu xấu hoặc tài liệu có bản quyền xin hãy email cho chúng tôi.
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.