TAILIEUCHUNG - Microprocessor systems a

Microprocessor systems a | Electronics Explained Microprocessor Systems Programming a RAM chip The circuit you will be assembling is shown below. The RAM can be any static RAM . which holds more than sixteen three-bit words with the standard 3-bit control bus. Most 2048 8 RAMs have the pinout of a 6116 . 1 Start off by setting up the data switches as follows. On the far right-hand end of your breadboard insert the LEDs driver three switches and 1 k pull-down resistors. Check that each LED glows when its switch is pressed. 2 Place your RAM . on the breadboard. Connect it to the supply rails. Connect any of the address inputs which you aren t going to use to either 5 V or 0 V. 3 Set up the four DIL switches and their . k pull-down resistors connected to the four address inputs. Use a voltmeter to check that each address switch can be used to feed 1 s and 0 s into the address inputs. 4 Now set up the three push switches and k pull-up resistors which fix the state of the control bus. Use a voltmeter to check that each control line goes low and high when the relevant control switch is pressed and released. 5 Test your circuit by entering 010 at location 0000 as follows set the address bus to 0h hold WR low and keep it there make the yellow LED glow by pressing its switch pulse CE low release all of the control and data switches pull both CE and RD low if all is well only the yellow LED should glow. 6 Try entering different 3-bit words at a variety of locations. Check that you can read them out again. 7 Program the RAM with a 16 step traffic light sequence. Then use a 1 Hz oscillator and a binary counter to run the LEDs through the sequence. Michael Brimicombe 12 02 .

TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.