TAILIEUCHUNG - The Risk Management of Safety and Dependability part_8

Vấn đề rủi ro cần phải được nhúng vào tâm thức của tất cả các kỹ sư và quản lý để cải thiện an toàn và đáng tin cậy. Các công ty có thể được tổ chức có trách nhiệm thông qua quy định của pháp luật khi một tổng thất bại trong quản lý sức khỏe và an toàn có hậu quả chết người. Quản lý rủi ro, cơ cấu tổ chức yêu cầu và các yếu tố chính cần thiết để thực hiện thành công của nó được khám phá. Những rủi ro phải được quản lý như. | Cause and symptoms of age and decay 197 software have been developed for the detection of antifriction bearing wear and fatigue. They use the Kurtosis technique for damage detection further information can be obtained from detector manufacturers. Velocity pickups Velocity pickups work by sensing the rate of change of flux in a sensing coil. Due to the use of moving parts they are less reliable than solid-state sensors. They are useful for monitoring machines with high levels of vibration at very high frequencies. Vibration acceptance criteria Internationally recognised acceptance criteria for factory testing of new machines as specified by the API are given in Table . Manufacturers can also provide recommended alarm settings. They will need to be adjusted based on operating experience. Alarm setting for maintenance Premature maintenance is costly. Operators will therefore need to build upon their own experience for each machine and determine the level of vibration that needs action. For this to be done the recording of baseline vibration signatures for each machine is paramount. Monitoring of trends on a specific machine basis will enable judgement on the machine s condition. Experience from a few shutdowns will enable adjustments to be made. It will be found that some machines are more sensitive than others to conditions that will cause excitation. One important criterion is the relative flexibility of the rotor. A sensitive rotor is one where the operating rpm first stiff bearing critical speed ratio is greater than unity. The gas density handled by a compressor is another. High gas density will result in more aerodynamic forces being generated. A combination of a sensitive rotor and high gas density can give rise to excitation at frequencies lower than the running speed. This is referred to as subsynchronous vibration. Centrifugal pumps because they pump liquids also experience these problems. To avoid these problems stiff shaft rotors with their first .

TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.