TAILIEUCHUNG - Cisco CCIP MPLS Study Guide phần 4

giao diện Ethernet0 không tắt máy địa chỉ ip! giao diện Serial0 mô tả Liên kết để Raleigh POP không công bằng-hàng đợi! giao diện Serial1 không tắt máy địa chỉ ip! router bgp 65002 không đồng bộ hóa bgp log-hàng xóm, thay đổi phân phối lại kết nối từ xa hàng xóm là 65000 không tự động tóm tắt! ip | 114 Chapter 3 MPLS and ATM A. MPLS is being configured for cell mode on an ATM edge-LSR. B. Cell-mode MPLS is being configured on an ATM-LSR. C. Frame-mode MPLS is being configured on an ATM edge-LSR. D. Frame-mode MPLS is being configured on an ATM-LSR. 10. Based on the following code what is being configured interface ATM1 0 mpls ip A. MPLS is being configured for cell-mode on an ATM edge-LSR. B. Cell-mode MPLS is being configured on an ATM-LSR. C. Frame-mode MPLS is being configured on an ATM edge-LSR. D. Frame-mode MPLS is being configured on an ATM-LSR. 11. ATM-LSRs use which of the following signaling protocols to exchange labels A. UNI B. MNI C. PNNI D. LDP 12. Which capability does Cisco use to preserve labels and ensure the proper assembly of cells A. Cell interleaving B. LDP C. VC merge D. None of the above 13. Which of the following command options configures an ATM edge-LSR for cell-mode MPLS A. tag-switching B. mpls C. point-to-point D. cell-mode Copyright 2002 SYBEX Inc. Alameda CA Review Questions 115 14. Which of the following command options configures an ATM edge-LSR for frame-mode MPLS A. tag-switching B. mpls C. point-to-point D. cell-mode 15. Which of the following command options configures an ATM edge-LSR for cell-mode tag switching A. tag-switching B. mpls C. point-to-point D. cell-mode 16. Which of the following commands enables VC merge on an ATM-LSR A. mpls Idp atm vc-merge B. mpls ip atm vc-merge C. mpls ip atm vcmerge D. mpls ip atm vc merge 17. By default VC merge is. A. Enabled B. Disabled 18. For cell-mode MPLS the default hop-count object TLV value is . A. 254 B. 16 534 C. 256 D. 16 536 Copyright 2002 SYBEX Inc. Alameda CA 116 Chapter 3 MPLS and ATM 19. Which of the following is used by both frame-mode and cell-mode MPLS to prevent loops A. TLV B. TTL C. Routing protocol D. None of the above 20. Based on the following code what is being configured interface ATM1 0 tag-switching ip A. Tag switching is .

Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.