TAILIEUCHUNG - Lab 7.3.6 Default Routing with RIP and IGRP

In this lab, a default route will be configured and RIP used to propagate this default information to other routers. When this configuration is working properly, the network will be migrated from RIP to IGRP and default routing will be configured to work with that protocol as well. Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram, such as 800, 1600, 1700, 2500, 2600 routers, or a combination, may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on. | Cisco SrsTEMS Lab Default Routing with RIP and IGRP Router designation Router Name Enable secret password Enable VTY and Console passwords Routing protocol RIP network statements 1 Router 1 Centre class cisco RIP Router 2 Boaz class cisco RIP Router 3 Mobile class cisco RIP Router designation IP Host Table Entry Fast Ethernet 0 address Interface type Serial 0 Serial 0 address Interface type Serial 1 Serial 1 address Subnet mask all addresses Router 1 Boaz Mobile DTE NA No address Router 2 Centre Mobile DCE DCE Router 3 Boaz Centre DTE NA No address Note The IP Host Table Entry column contents indicate the name s of the other router s in the IP host table. Straight-through cable --------------------------------- Console Rollover . Serial cable S _ Crossover cable Objective Configure a default route and use RIP to propagate this default information to other routers. Migrate the network from RIP to IGRP. Configure default routing to work with IGRP Background Preparation In this lab a default route will be configured and RIP used to propagate this default information to other routers. When this configuration is working properly the network will be migrated from RIP to IGRP and default routing will be configured to work with that protocol as well. Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram such as 800 1600 1700 2500 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps .

TỪ KHÓA LIÊN QUAN
TAILIEUCHUNG - Chia sẻ tài liệu không giới hạn
Địa chỉ : 444 Hoang Hoa Tham, Hanoi, Viet Nam
Website : tailieuchung.com
Email : tailieuchung20@gmail.com
Tailieuchung.com là thư viện tài liệu trực tuyến, nơi chia sẽ trao đổi hàng triệu tài liệu như luận văn đồ án, sách, giáo trình, đề thi.
Chúng tôi không chịu trách nhiệm liên quan đến các vấn đề bản quyền nội dung tài liệu được thành viên tự nguyện đăng tải lên, nếu phát hiện thấy tài liệu xấu hoặc tài liệu có bản quyền xin hãy email cho chúng tôi.
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.