TAILIEUCHUNG - Lab 6.2.3 Managing the MAC Address Table

Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Start a HyperTerminal session. Note: Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. | Cisco Systems I OK for all switches. Lab Managing the MAC Address Table Switch Designation Switch Name Enable Secret Password Enable VTY and Console Passwords VLAN 1 IP Address Default Gateway IP Address Subnet Mask Switch 1 AL Switch class cisco Straight-through cable Serial cable Console Rollover Crossover cable Objective Create a basic switch configuration. Manage the switch MAC table. Background Preparation Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Start a HyperTerminal session. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. 1 - 7 CCNA 3 Switching Basics and Intermediate Routing v - Lab Copyright 2003 Cisco Systems Inc. Step 1 Configure the switch Configure the hostname access and command mode passwords as well as the management LAN settings. These values are shown in the chart. If problems occur while performing this configuration refer to the Basic Switch Configuration lab. Step 2 Configure the hosts attached to the switch Configure the hosts to use the same IP subnet for the address mask and default gateway as on the switch. Step 3 Verify connectivity a. To verify that hosts and switch are correctly configured ping the switch IP address from the hosts. b. Were the pings successful c. If the answer is no troubleshoot the hosts and switch configurations. Step 4 Record the MAC addresses of the host a. Determine and record the layer 2 addresses of the PC network interface cards. If running Windows 98 check by using Start Run winipcfg then click on More info. If running Windows 2000 check by using Start Run cmd ipconfig .

TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.