TAILIEUCHUNG - Lab 4.2.3 Suspending and Disconnecting Telnet Sessions

This lab focuses on the ability the Telnet to a router, suspend that session, return to the local router console and then re-establish the previous connection. Cable a network similar to the one in the previous diagram. Any router that meets the interface requirements may be used. Possible routers include 800, 1600, 1700, 2500 and 2600 routers, or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce slightly. | Cisco SrsTEMS Lab Suspending and Disconnecting Telnet Sessions Router 1 Router 2 Straight-through cable Serial cable Rollover console Crossover cable Router ID Router Name FastEthernet 0 Address Interface type Serial 0 Address Subnet mask Routing protocol Enable secret passwor d Enable VTY and console password Router 1 GAD DCE RIP class cisco Router 2 BHM DTE RIP class cisco Objective Establish a Telnet session with a remote router. Suspend and re-establish a telnet session. Display active Telnet sessions. Disconnect a Telnet session. Background Preparation This lab focuses on the ability the Telnet to a router suspend that session return to the local router console and then re-establish the previous connection. Cable a network similar to the one in the previous diagram. Any router that meets the interface requirements may be used. Possible routers include 800 1600 1700 2500 and 2600 routers or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 1 - 4 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. Step 1 Configure the routers a. If there are any difficulties configuring hostname or passwords refer to the Configuring Router Passwords lab. If there are any difficulties configuring Interfaces or the routing protocol refer to the Configuring Host Tables lab. Step 2 Login to .

TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.