TAILIEUCHUNG - Chapter 8 - CCNP ROUTE

What is an advantage of the NAT-PT technique for transitioning between IPv4 and IPv6? All mappings are static. Globally routable IPv4 addressing is not required. DNS is not required. No configuration is required on end nodes. How do IPv6 enabled routers handle packet fragmentation? IPv6 routers do not perform packet fragmentation. OSPFv3 has a mechanism for determining the optimal packet size and dynamically adjusting the packet size. IPv6 routers do not perform packet fragmentation. CDP is used to discover the correct packet size for any given traffic flow | 111 111 CISCO Close Window Assessment System 1. Assessment Selection 2. Assessment Settings 3. Take Assessment Take Assessment - ROUTE Chapter 8 - CCNP ROUTE Version Time Remaining 1 Which method can be used to route traffic through a 6to4 automatic tunnel IPv6 static route IPv4 static route OSPFv2 OSPFv3 RIPv2 RIPng 2 What is an advantage of the NAT-PT technique for transitioning between IPv4 and IPv6 All mappings are static. Globally routable IPv4 addressing is not required. - -1 DNS is not required. No configuration is required on end nodes. 3 How do IPv6 enabled routers handle packet fragmentation r IPv6 routers do not perform packet fragmentation. OSPFv3 has a mechanism for determining the optimal packet size and dynamically adjusting the packet size. r IPv6 routers do not perform packet fragmentation. CDP is used to discover the correct packet size for any given traffic flow. The correct packet size is unique for each traffic flow. r IPv6 routers perform packet fragmentation. CDP is used to determine which packets need to be fragmented for any given traffic flow. r IPv6 routers perform packet fragmentation. OSPFv3 has a mechanism for fragmenting packets so that they are the optimal size. IPv6 routers do not perform packet fragmentation. A discovery process is used to determine the optimum maximum transmission unit MTU to use during a given session. r IPv6 routers perform packet fragmentation. IPv6 built-in QoS mechanisms automatically adjust the packet fragmentation for a given session. 4 Edg-R1 config interface tunnel 124 Edg-R1 config-if no ip address Edg-R1 config-if ipv6 address 12 4 64 Edg-RI config-if tunnel source Edg-RI config-if tunnel destination Edg-RI config-if keepalive 10 Edg-R1 config-if end Edg-R1 copy running-config startup-config Refer to the exhibit. What is the purpose of this configuration to protect the IPv6 traffic from being corrupted by the IPv4 traffic to transport IPv6 traffic through an IPv4 .

TỪ KHÓA LIÊN QUAN
TAILIEUCHUNG - Chia sẻ tài liệu không giới hạn
Địa chỉ : 444 Hoang Hoa Tham, Hanoi, Viet Nam
Website : tailieuchung.com
Email : tailieuchung20@gmail.com
Tailieuchung.com là thư viện tài liệu trực tuyến, nơi chia sẽ trao đổi hàng triệu tài liệu như luận văn đồ án, sách, giáo trình, đề thi.
Chúng tôi không chịu trách nhiệm liên quan đến các vấn đề bản quyền nội dung tài liệu được thành viên tự nguyện đăng tải lên, nếu phát hiện thấy tài liệu xấu hoặc tài liệu có bản quyền xin hãy email cho chúng tôi.
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.