TAILIEUCHUNG - Chapter 5 - CCNP ROUTE

A BGP routing policy has been created using route maps. The command route-map TEST permit 10 is part of the configuration. What does the argument 10 indicate? It identifies the access list number to be used by the route map statement. It identifies the position of the route map in relation to other instances. It indicates the local preference to be set for routes that match the route map. It indicates the metric to be set for routes that match the route map. It specifies the route map to be used on autonomous system 10 | 111 111 CISCO Close Window Assessment System 1. Assessment Selection 2. Assessment Settings 3. Take Assessment Take Assessment - ROUTE Chapter 5 - CCNP ROUTE Version Time Remaining 1 Routing protocol convergence time would be an example of which path control consideration adaptability availability performance predictability resiliency 2 A BGP routing policy has been created using route maps. The command route-map TEST permit 10 is part of the configuration. What does the argument 10 indicate It identifies the access list number to be used by the route map statement. It identifies the position of the route map in relation to other instances. It indicates the local preference to be set for routes that match the route map. It indicates the metric to be set for routes that match the route map. It specifies the route map to be used on autonomous system 10. 3 24 24 R1 config router rip R1 config-router version 2 R1 config-router offset-list 11 out 3 Serial 0 0 0 R1 config-router network R1 config access-list11 Refer to the exhibit. What would be the RIP routing metric for the subnets of the 16 network on the R2 router after the configuration in the exhibit was applied to the R1 router c 1 2 3 4 5 4 Refer to the exhibit. The routing policy for router R1 states that traffic from the LAN network is to be routed to ISP-1 and traffic from the LAN network is to be routed to ISP-2. However the network administrator notices that a host at IP address is being routed out Serial0 0 0. What is the cause of the problem The route map ISP-1 should be applied to Serial0 0 0. The route map ISP-2 should be applied to FastEthernet0 1. The route maps are applied to opposite interfaces. There is an incorrect access list 1 statement. There is an incorrect access list 2 statement. 5 What are three accurate descriptors of the functionality of the Cisco IOS IP SLA feature Choose .

TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.