TAILIEUCHUNG - FREQUENCY MODULATION

Frequency Modulation FM results when the time derivative of the phase of the carrier is varied linearly with the message signal m(t). The frequency deviation is proportional to the derivative of the phase deviation. Thus, the instantaneous frequency of the output of the FM modulator is maximum when the message signal m(t) is maximum and minimum when m(t) is minimum. Carson’s Rule: Carson’s Rule is used to determine the bandwidth of the FM wave. According to Carson’s Rule, the bandwidth is given by:. | EXPERIMENT 4 FREQUENCY MODULATION Page 1 Purpose The objectives of this laboratory are 1. To investigate frequency modulation characteristics in the frequency domain. 2. To implement a classical double-tuned FM demodulator and measure its characteristics. 3. To implement a modern PLL FM demodulator and measure its characteristics. 4. To investigate the effect of FM signal bandwidth on the detected signal-to-noise ratio. Equipment List 1. PC with Matlab and Simulink Page 2 Frequency Modulation FM results when the time derivative of the phase of the carrier is varied linearly with the message signal m t . The frequency deviation is proportional to the derivative of the phase deviation. Thus the instantaneous frequency of the output of the FM modulator is maximum when the message signal m t is maximum and minimum when m t is minimum. Carson s Rule Carson s Rule is used to determine the bandwidth of the FM wave. According to Carson s Rule the bandwidth is given by BW 2 P 1 fm. Hertz. Laboratory Procedure Determining Constants Before proceeding to perform the experiment the following steps were performed 1. Calibrate the multiplier and determine the multiplier constant. 2. Determine the VCO conversion constant Ko 3. Set the VCO s frequency for 5 kHz. 4. Verify the outputs of the 1st order Low Pass Filter. 1. Multiplier Constant Km With a 1V p-p sinusoidal voltage at both inputs of the multiplier the output was observed and the multiplier constant was calculated to be . 2. VCO Conversion Constant Ko An external voltage may control the output frequency of the VCO. The change in the output frequency per change in the dc input voltage was measured. Ko Af Av Ko 1 2 kHz sec volt .Ko 4n103 125 66 rad sec volt Page

TỪ KHÓA LIÊN QUAN
TAILIEUCHUNG - Chia sẻ tài liệu không giới hạn
Địa chỉ : 444 Hoang Hoa Tham, Hanoi, Viet Nam
Website : tailieuchung.com
Email : tailieuchung20@gmail.com
Tailieuchung.com là thư viện tài liệu trực tuyến, nơi chia sẽ trao đổi hàng triệu tài liệu như luận văn đồ án, sách, giáo trình, đề thi.
Chúng tôi không chịu trách nhiệm liên quan đến các vấn đề bản quyền nội dung tài liệu được thành viên tự nguyện đăng tải lên, nếu phát hiện thấy tài liệu xấu hoặc tài liệu có bản quyền xin hãy email cho chúng tôi.
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.