TAILIEUCHUNG - service manual 5&571

MAIN CID () / 350 CID ()Printed in . 1999, Mercury Marine90-861327--1 #24 GM CID () / 350 CID ()90-861327--190-iMerCruiser #24 GM CID () / 350 CID (). this publication, “Dangers”, “Warnings” and “Cautions” (accompanied by the International HAZARD Symbol.) are used to alert the mechanic to special instructions concerning a particular service or operation that may be hazardous if performed incorrectly . OBSERVE THEM CAREFULLY!.These “Safety Alerts” alone cannot eliminate the hazards that they signal. Strict these special instructions when performing the service, plus “Common Sense” operation,.are major accident prevention - Immediate hazards which WILL result in severe personal injury or - Hazards or unsafe practices which COULD result in severe personal injury or or unsafe practices which could result in minor personal injury or property to Users of This service manual has been written and published by the Service Department of to aid our dealers’ mechanics and company service personnel when servicing described hereinIt is assumed that these personnel are familiar with the servicing procedures of these products, or like or similar products manufactured and marketed by Mercury Marine, that been trained in the recommended servicing procedures of these products which includes the use of mechanics’ common hand tools and the special Mercury Marine or recommended tools from other suppliersWe could not possibly know of and advise the service trade of all conceivable which a service might be performed and of the possible hazards and/or results of . We have not undertaken any such wide evaluation. Therefore, anyone who service procedure and/or tool, which is not recommended by the manufacturer, first satisfy himself that neither his nor the products safety will be endangered by procedure selectedAll information, illustrations and specifications contained in this manual are based on product information available at the time of publication. As required, revisions to will be sent to all dealers contracted by us to sell and/or service these productsIt should be kept in mind, while working on the product, that the electrical system and are capable of violent and damaging short circuits or severe electrical shocks. any work where electrical terminals could possibly be grounded or touched mechanic, the battery cables should be disconnected at the batteryAny time the intake or exhaust openings are exposed during service they should be protect against accidental entrance of foreign material which could enter the cylinders extensive internal damage when the engine is OCTOBER 1999Page is important to note, during any maintenance procedure replacement fasteners must same measurements and strength as those removed. Numbers on the heads of the metric bolts and on the surfaces of metric nuts indicate their strength. American bolts use for this purpose, while most American nuts do not have strength markings. Mismatched or incorrect fasteners can result in damage or malfunction, or possibly . Therefore, fasteners removed should be saved for reuse in the same locations whenever possible. Where the fasteners are not satisfactory for re-use, care should be taken a replacement that matches the and Care of Outboard marine power product is a combination of many machined, honed, polished and with tolerances that are measured in the ten thousands of

TỪ KHÓA LIÊN QUAN
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.