TAILIEUCHUNG - Effect and Optimization of Machine Process Parameters on MRR for EN19 & EN41 materials using Taguchi
(BQ) The present work deals with the comparison of the MRR for EN19 and EN41 material in a die sinking EDM machine. The various input factors like Pulse ON time, Pulse OFF time, Discharge current and voltage were considered as the input processing parameters, while the MRR is considered as the output. Optimization using Taguchi method was performed to predict the best combination of inputs towards maximum output. A comparison was done to obtain the effect of these input parameters over the MRR for both the material, and simultaneously the impact of the carbon percentage over the MRR was investigated. | Available online at ScienceDirect Procedia Technology 14 (2014) 204 – 210 2nd International Conference on Innovations in Automation and Mechatronics Engineering, ICIAME 2014 Effect and Optimization of Machine Process Parameters on MRR for EN19 & EN41 materials using Taguchi tool steel Vikasa, Shashikanta, and Kaushik Kumarb* b a Research Scholar, Department of Mechanical Engineering, Birla Institute of Technology, Mesra, Ranchi, 835215, India Associate Professor, Department of Mechanical Engineering, Birla Institute of Technology, Mesra, Ranchi, 835215, India Abstract The present work deals with the comparison of the MRR for EN19 and EN41 material in a die sinking EDM machine. The various input factors like Pulse ON time, Pulse OFF time, Discharge current and voltage were considered as the input processing parameters, while the MRR is considered as the output. Optimization using Taguchi method was performed to predict the best combination of inputs towards maximum output. A comparison was done to obtain the effect of these input parameters over the MRR for both the material, and simultaneously the impact of the carbon percentage over the MRR was investigated. It was found that the Discharge current in case of the EN41 material and EN19 material had a larger impact as compare to other processing parameters on the MRR. A relative study of the carbon composition for both the material was also done. © 2014 Elsevier Ltd. This is an open access article under the CC BY-NC-ND license © 2014 The Authors. Published by Elsevier Ltd. (). Selection and/or peer-review under responsibility of the Organizing Committee of ICIAME 2014. Peer-review under responsibility of the Organizing Committee of ICIAME 2014. Keywords: EN19, EN41, EDM, MRR,Taguchi, Design of Experiments, Optimization * Corresponding author. Tel.: +91-9431597463. E-mail address: kkumar@ 1. Introduction In an EDM .
đang nạp các trang xem trước
