Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ
Tải xuống
Hướng dẫn 3: Mô hình hóa hình chữ L-Rod và biểu diễn Phân tích phần tử hữu hạn bằng cách sử dụng Pro / Mechanica | MAE 244 Dynamics and Strength Laboratory Fall 2005 Tutorial Material for Pro ENGINEER Wildfire 2.0 With Integrated Pro MECHANICA Tutorial 3 Modeling L-Shaped Rod and Performing Finite Element Analysis using Pro MECHANICA Chuanyu Feng PhD chuanyufeng@yahoo.com MAE 244 Dynamics Strength Laboratory Fall 2005 Introduction This tutorial is similar to Tutorial 2. The difference is that in this part you will use Sweep feature to make an L-Shaped Rod and then apply proper boundary conditions and loads to analyze it. Create an L-Shaped Rod In this session you will make a simple Pro E part and further practice the basic modeling technique sketching and sweep. Starting Pro E and Creating new Part 1. Start Pro E Wildfire. 2. Click menu File New. A dialog will pop up Figure 1 3. Give a new name and or description if desired. 4. Click OK button and Pro E will create an empty solid part as shown in Figure 2. Figure 1. New Dialog Chuanyu tony Feng 2 MAE 244 Dynamics Strength Laboratory Fall 2005 Figure 2. Layout of an empty Pro E part Sketch and Sweep 1. Click the Top Reference plan. This is where you draw a sketch. 2. Click the Sketch tool 1. All the information should be filled up Figure 3 3. Click Sketch button in Figure 3. 4. Now Pro E is in the Sketch mode. This will allow you to sketch in the XZ plane 5. Close the References window by click close button Figure 4 . Chuanyu tony Feng
