Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ
Tải xuống
Upon completion of this lab, the student will be able to partition the hard drive. The student will also be able to install the three system files onto the hard drive to make it a bootable drive. | Lab 5.4.2 Hard Drive Preparation Using FDISK and FORMAT Estimated time 30 Minutes Objective Upon completion of this lab the student will be able to partition the hard drive. The student will also be able to install the three system files onto the hard drive to make it a bootable drive. Note This procedure will erase any current information on the lab computer s hard. Before proceeding make sure to use only components that can be erased and copied to. Equipment The following equipment is required for this exercise A lab computer Bootable floppy disk with DOS FDISK and FORMAT commands Scenario A new hard drive has been installed and it needs to be prepared for the operating system. In order to do this the dos fdisk and format commands will need to be used. Procedures After installing a hard drive into a computer it must be prepared in order for the computer to communicate with it during the boot process. Using the DOS commands FDISK and FORMAT the hard drive can be partitioned and prepared for communication and usage. Step 1 Boot up the computer using a bootable floppy disk with the FDISK and FORMAT commands on it. Step 2 To create and remove partitions first start the FDISK program. Type FDISK at the prompt and then press Enter. Once the application starts select option 4 to check and verify current partitions before attempting to delete any partitions. Now select the partition type to delete from the menu that displays. They are Primary DOS partition Extended DOS partition Logical DOS drives in the Extended partition and a Non-DOS partition. If there are logical drives defined in the Extended partition they need to be removed before the Extended partition is removed. To delete any partition simply select the option that correlates with the partition to be removed and follow the directions on the screen. Step 3 Once all the partitions have been removed from the drive return to the main menu and select option 1 to create a DOS partition. Then from the next menu .
